traeger error codes

How to Fix LEr Code on Traeger
Check the fire pot for dust, make sure your grill is clean as it might be a cause of your low temp.There might be problems with a heat sensor. So, restart it and see how it goes further.Maybe there are problems with p- setting, which is ‘p’ setting. You should restart it too.

How do I reset my Traeger?

For a soft reset, power off your smartphone or tablet with the Traeger app. Wait a few minutes, then turn the phone back on. Then, power off the grill by switching the power switch off. Wait 30 seconds and then turn the grill back on using the same switch.

What does LEr mean on Traeger?

A Low Error Reading of LEr, is an error message you may see on an AC platform Grills (non-WiFIRE enabled) except the 2017 AC Timberline 850/1300. Getting this message means that your grill dropped below 125 degrees for more than 10 minutes and caused the grill to shut off.

How do you fix a high temp error on a Traeger?

High Temp Error
Clean out the firepot > Place 5-10 pellets back into the firepot > Restart Grill.D2 grills require a “closed-lid start up,” meaning you should start your grill with the lid shut. Failure to do so will often result in temperature irregularities through the duration of your cook.

Why is my Traeger grill not getting hot?

Why isn’t my grill getting hot enough? Poor airflow in the grill, which can be caused by too much ash buildup in the firepot, rusted holes in the firepot, a tightened chimney cap, a weak induction fan, or the RTD temperature probe inside the grill is dirty or leaning towards the body of the grill.

How do I update my Traeger WiFi?

Reset the grill’s WiFi.
On your controller navigate to MENU > WIFI INFORMATION.While on the WIFI INFORMATION screen, press and hold the IGNITE button for 10 seconds.Power Cycle the grill.Turn off and unplug the grill.Flip the power switch to the on position and wait 10 seconds.

What is HEr error on Traeger?

A HEr error stands for “High Error Reading. ‘” This usually happens when the grill reaches over 550 degrees and shuts itself off. To understand why let’s run through a few scenarios that could have caused this error.

Why is my pellet grill not getting hot?

The main reasons a pellet grill won’t heat up comes down to old or moist pellets, blocked fire pot, bad weather conditions, or problems with the auger.

How do you know if your Traeger Hot Rod is bad?

Check the Hot Rod
If the Induction Fan turns on – the controller is fine, and the Hotrod is bad.If the Hotrod turns on (3+ minutes) and the induction fan does not – the controller is bad, and the components are fine.If neither component is turning on – the controller and the Hotrod need to be replaced.

How often should you clean out your Traeger?

We recommended cleaning your wood pellet grill once every five grills on average. Your grill should also be cleaned after every extended grill as well (over 8 hours).