rain bird sprinkler head

Spray Heads & Nozzles
1800 Series High Efficiency Spray Heads with Dual Spray & HEVAN Nozzles. 1800® Series (PRS) Pressure Regulated Spray Heads. 1800® Series (PRS) Pressure Regulated Spray Heads. 5 Series Specialty Stream Bubbler Nozzles. A17 Plastic Shrubbery Spray Nozzles. AP Series Adjustable Pattern Spray Nozzles.

Are Rainbird Sprinkler heads good?

Sure, there are other types of lawn sprinkler systems. But for homeowners who want a sprinkler system that is well-built, reliable and relatively affordable, Rainbird and Hunter sprinkler systems represent the gold standards, the best of the best, the right way to water your lawn.

How do I choose a sprinkler nozzle?

one will need a nozzle 1/2 the size. (Remember: when you reduce the RADIUS by 1/3 you reduce the AREA by a little more than half.) Avoid using rotors with nozzle flows that are less than 2.5 GPM, except in corners (quarter circle patterns). Flows under 2.5 GPM give very poor coverage due to the tiny water stream.

How do you fix a Rainbird sprinkler head that won’t rotate?

How to Do It
Disassemble the sprinkler head. Take off the filter at the bottom of the head. Rinse the filter in a bucket filled with clean water to wash out debris.If this doesn’t work you’ll need to have the sprinkler head replaced. If it does work, make sure the head is properly adjusted when you re-install it.

Which is better Rainbird or Hunter?

Hunter products are slightly more durable than Rainbird. They can handle a greater PSI which is important when it comes to water pressure, winterization and extreme weather. Sprinkler heads sit in the ground which experience extreme temperatures.

Which are the best sprinkler heads?

Orbit 58573N Gear Drive Sprinkler.Rain-bird 5000 Series Rotor Sprinkler Head.HUNTER PGP-adj Rotor Sprinkler Heads.Gilmour 167H Pulsating Sprinkler Head.Bosch Garden Impulse Sprinkler Head.

Who makes Rainbird?

Rain Bird Corporation is a leading global manufacturer and provider of irrigation products and services headquartered in Azusa, California. The privately held company was founded in 1933 during California’s agricultural boom.

Are sprinkler head brands interchangeable?

A replacement sprinkler head doesn’t have to be the same brand as the broken head. But it does have to be the same type: pop-up (stationary, rotor- or gear-driven rotor) or impact. And the new head must also match the inches-per-hour (iph) or gallons-per-minute (gpm) delivery rate of the old head.

Does orbit nozzles fit Rainbird?

The brass adjustable pattern spring loaded pop-up nozzle will provide years of durable service. Fits Orbit, Rain Bird and Hunter pop-up sprinklers. Easy pattern adjust from 25 degrees to 360 degrees.

Where are Hunter sprinklers made?

The company’s irrigation and landscape lighting products are used in a wide array of locations including sports stadiums, national landmarks, hotels, and city parks. Manufacturing facilities are located in San Marcos, California, and Tijuana, Mexico, and the company also has overseas offices in China.

What is a low angle sprinkler nozzle?

A low angle nozzle is intended to spray water under low overhanging branches, or to keep the spray down close to the ground in windy areas. The reduced radius was not a primary goal of the low angle nozzle, it’s just a natural result of a low trajectory.

What do the numbers on Hunter nozzles mean?

By referring to the Hunter PGP performance chart you will note the following: • As the nozzle size goes up the flow rate goes up. I.e. the flow rate on a Number 1 nozzle is. AT 206 KPA is 1.8 Litres per Minute (LPM), while a number 6 nozzle at the same pressure (206 KPA) has a flow rate of 7.4 LPM.

How many gallons per minute does a Rain Bird sprinkler use?

WE UPPED THE PRESSURE AND COMPARED FLOW RATES

However, the flow rate of the Rain Bird PRS spray held steady at 2.1 gallons per minute, saving almost a gallon per minute over the non-PRS spray.